Advanced Use of the GCM

Running in parallel

For large simulation (long run, high resolution etc...), the waiting time can becomes very long. To overcome this issue, the model can works in parallel. It first needs to be compiled in parallel mode and then be run with a specific command. For all the details see the page Parallelism

Distinctions beween ifort, mpi, etc.

TO BE COMPLETED BWAAAAA

Distinction between using IOIPSL or XIOS

TO BE COMPLETED

How to Change Vertical and Horizontal Resolutions

To run at a different grid resolution than available initial conditions files, one needs to use the tools newstart.e and start2archive.e

For example, to create initial states at grid resolution 32×24×25 from NetCDF files start and startfi at grid resolution 64×48×32 :

• Create file start_archive.nc with start2archive.e compiled at grid resolution 64×48×32 using old file z2sig.def used previously
• Create files restart.nc and restartfi.nc with newstart.e compiled at grid resolution 32×24×25, using a new file z2sig.def (more details below on the choice of the z2sig.def)

What you need to know about the z2sig.def file (change of vertical resolution only)

TO BE COMPLETED

How to Change the Topography (or remove it)

The generic model can use in principle any type of surface topography, provided that the topographic data file is available in the right format, and put in the right place.

How to Change the Opacity Tables

TO BE COMPLETED

How to Manage Tracers

Tracers are managed thanks to the traceur.def file.

Specific treatment of some tracers (e.g., water vapor cycle) can be added directly in the model and an option added in callphys.def file.